Lyntec RPC Manual de usuario descargar pdf (Pagina 35)

139-0498-01.35 35

Chapter Five--Control Setup

Contact Closure Setup

Con gure the digital I/O port and link it to a zone as follows:

Note: If the Emergency Shuto feature is selected, the  rst

position in the Onboard  eld (on the Controller) is automatically

assigned to that.

1. Rename each contact closure as desired

2. Select contact closure action type

3. Use CC Module 1 and CC Module 2 only if I/O Expander

boards are installed.

4. Save Changes

Figure 5-18

Assigning Contact Closures to Zones To assign a contact closure to a zone in the “Panel” screen:

1. Select the desired zone from the drop down box.

2. Save changes.

Figure 5-19

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 56 57

Sin comentarios

Lyntec RPC Manual de usuario Pagina 35