
139-0498-01.10
Chapter Three--Quick Start Guide
10
Steps Reference
1. Install all the RPC components according to
their instruction bulletins. Typical components
include, but are not limited to, the following:
• circuit breakers
• controller
• control bus
• power supply
• voltage transducer
• slave address selectors
See appropriate instruction bulletins.
Chapter 4--Wiring
2. Wire all RPC components according to their
instruction bulletins.
See appropriate instruction bulletins.
3. Connect the controller to a computer or
network for panel setup.
Chapter 4--Wiring
4. Access the web page by entering the IP address
or NetBIOS name into web browser.
Chapter 5--Control Setup
5. Complete the panel setup. Chapter 5--Control Setup
6. Connect the controller to a secondary
controller or add contact closures if necessary.
Chapter 4--Wiring
Chapter 5--Control Setup
7. If your RPC system does not operate as
expected, verify that everything is installed and
programmed correctly.
Appendix A--Troubleshooting
Chapter Three--Quick Start Guide
INTRODUCTION
This chapter is a quick reference listing the steps necessary to
install the RPC system. The steps in this chapter are provided as
an installation checklist. For complete installation instructions,
refer the chapter listed.
Comentarios a estos manuales